Sdc 1591U EMLOCK User Manual download pdf

SECURITY DOOR CONTROLS

801 Avenida Acaso, Camarillo, Ca. 93012 • (805) 494-0622 • Fax: (805) 494-8861

www.sdcsecurity.com • E-mail: [email protected]

1591U EMLOCK

INSTALLATION INSTRUCTIONS

1. Prepare door jamb for EMLock per template drawing.

2. Locate reinforcement plate and mounting tabs as shown.

3. Center Armature Plate to the centerline of the lock. The cutout for the armature must be 1-1/2” wide

and 6-1/2” long.

4. Install an armature reinforcement plate or the Amp mounting plate so that there is a 5/8” pocket when

measured from the leading edge of the door. The AMP mounting plate is used to reinforce the mortise

cutout in a wood door. It is secured to the door with four (4) #10 wood screws and then the EMLock

armature is secured to the mounting plate with a 5/16”-18 x 3/4” bolt.

NOTE: The AMP mounting plate is an option available from SDC.

5. Attach the EMLock wire leads to the power source and then install the EMLock and the armature with

screws provided.

SYSTEM WIRING

ELECTRONICS

24V CONFIGURATION

BLK

RED

ORG

WHT

(+) RED/BLK

TO 24 VDC

FUSED

POWER SOURCE

(-) WHT/BLK

RED

ACCESS, EGRESS

AND

REMOTE CONTROLS

ELECTRONICS

12V CONFIGURATION

BLK

RED

ORG

WHT

(+) RED/BLK

(-) WHT/BLK

RED

ACCESS, EGRESS

AND

REMOTE CONTROLS

TO 12 VDC

FUSED

POWER SOURCE

IMPORTANT WIRING INFORMATION:

Use the system wiring diagram to configure the EMLock for 12 VDC or 24 VDC operation.

Although using a DC power supply is recommended, a transformer with a bridge rectifier may also be used

as a DC power source. If you are using a transformer and rectifier, a transformer with the correct output

voltage must be used.

Access controls must not be wired to the AC side of the bridge rectifier or power supply. Access controls

must always be wired to break the DC side of the power source.

P:\INSTALLATION INST\Electromagnetic Locks\INST-1591U.vsd REV A 06-11 Page 1

1 2

Summary of Contents

Page 1 - SECURITY DOOR CONTROLS

SECURITY DOOR CONTROLS801 Avenida Acaso, Camarillo, Ca. 93012 • (805) 494-0622 • Fax: (805) 494-8861www.sdcsecurity.com • E-mail: service@sdcse

Page 2 - 1591U EMLOCK

DOOR AND FRAME PREPARATION1591U EMLOCK®2 RUBBERWASHERS5/16 x 8SCREWARMATURESPACERREINFORCEMENT1 STEELWASHER1.025.680REINFORCINGARMATURE1591 EMLOCK.500

Comments to this Manuals

No comments

Sdc 1591U EMLOCK User Manual

Browse online or download User Manual for For Home Sdc 1591U EMLOCK. SDC 1591U EMLOCK User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For Home Sdc 1591U EMLOCK