INSTALLATION INSTRUCTIONS LR100MBSK
ELECTRIC LATCH RETRACTION KIT
MODELS: Q1100 & QF1100
P:\INSTALLATION INST\SWITCH KITS\INST-LR100MBSK.vsd REV - 05-14 Page 1
Any suggestions or comments to this instruction or
product are welcome. Please contact us through
our website or email engineer@sdcsecurity.com
Step 1
Attach the shorter end of link to
the clevis of the Electric Latch
Retraction assembly, then slide
the assembly into the device and
attach the larger open end of the
linkage to the rod inside at the
bottom of the Push Bar.
Step 2
Carefully slide the assembly
back out until the linkage JUST
makes contact with the latch
retraction rod. Tighten set
screws.
ELECTRICAL DATA
24VDC @ 700/200mA
RED (+) BLK (-)
PATENT PENDING
801 Avenida Acaso, Camarillo, Ca. 93012 • (805) 494-0622 •
www.sdcsecurity.com • E-mail: service@sdcsecurity.com
SET
SCREWS
TIGHTEN SET
SCREWS TO
LOCK DEVICE
IN POSITION
When retrofitting to existing vertical rod
devices, adjustment of the rods is required for
proper operation of the Electric Latch Retractor.
Once the unit is properly installed, energize it
so the push pad is dogged down, then
reconnect the vertical rods to the device and
make the proper adjustments.
Comments to this Manuals